Panasonic WJ-HD309 - Manual (Page 101)

101
[Screenshot 2]
The "VMD Setup" window will be displayed.
x Rotate the jog dial to select "SETUP AREA" on the status
bar.
Note: To set all areas on the monitor as the motion
detection area, select "ALL AREAS" and press the
SET button.
[Screenshot 3]
The cross cursor will be displayed on the "VMD Setup" win-
dow.
c Move the cross cursor to a desired point to be set as
the start point of the motion detection area using the
arrows button, and press the SET button.
[Screenshot 4]
The start point of the motion detection area is assigned.
v Move the cross cursor to a desired point to be set as
the end point of the motion detection area using the
arrows button, and press the SET button.
[Screenshot 5]
The motion detection area is set with the start point and the
end point as the points at opposite angles of the motion
detection area.
b Repeat steps 3 and 4 to set another motion detection
area.
Up to 4 areas can be set. The newly created areas will
be named automatically as A, B, C and D in the order of
creation.
n To complete the settings, rotate the jog dial to select
"EXIT" on the status bar, and press the SET button.
→ The "VMD Setup" window will be closed.
● Delete the motion detection area
[Screenshot 1]
Start operation from the "VMD Setup" window.
z Rotate the jog dial to select "DELETE AREA" on the sta-
tus bar.
Note: After selecting "DELETE ALL AREAS", pressing
the SET button will delete all of the motion detection
areas.
[Screenshot 2]
The cross cursor will be displayed on the "VMD Setup" win-
dow.