Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 101)

Comm. Method
Key Press Sound
Buzzer Sound Host Link
OFF
Putting-Out Time
Resume Function
OFF
None
ON
[ MEMORY SWITCH MENU (1/2) ]
Support Tool Mode NT600S
EXIT
SAVE
EXIT
NEXT
PAGE
Automatic Reset
Host Link Speed ON
19200bps
[ MEMORY SWITCH MENU (2/2) ]
EXIT
SAVE
EXIT
PREV.
PAGE
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
     
   -  $0&  1   .
 -  
Section 3-6
Select “NEXT PAGE”.
If the communication method is
not displayed as host link, press
“Comm. Method” to select “Host
Link”.
Each time the “Host Link Speed”
touch switch is pressed, the set-
ting option “9600 bps” alternates
with “19200 bps”.
To set and quit the menu, press the [SAVE EXIT] touch switch. To quit without set-
ting, press [EXIT].
4-6-3 Setting Unit Numbers (NT Link 1:N Only)
When using NT600S with the NT link (1:N) communication method, set unit num-
bers.
When using NT link (1:N), unit numbers are used to identify each of the multiple
PTs connected to a single PC port. Set a different unit number for each of the PTs
connected to the port.
The unit numbers that can be set differ in accordance with the type of host PC as
follows.
C200HE :Unit Nos. 0 to 3
C200HG, C200HX :Unit Nos. 0 to 7
Set the unit numbers by following the menu operation from the System Menu de-
scribed below.
Select “Maintenance Mode”.