Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 217)




!"#" % 
 1   
Section 6-1
Operation by Operating Commands
The following describes control of the NT600S using the operating commands,
and the flow of notifications from the NT600S.
For the actual procedure for using the operating commands, refer to 7-2 Com-
mands Sent by the Host (page 208) and 7-3 Commands Sent by the NT600S
(page 218).
The operating commands display monitored data from the production line and
messages to the factory workers. They are also used for NT600S control and
management.
The communication flow between the Host and NT600S differs according to the
following three cases:
Message from Host to NT600S
Host program NT600S operation
Message to PT Process message
Message operating command
Enquiry from Host to NT600S
Host program NT600S operation
Enquiry operating command
Enquiry
Receive command
Receive command
Send response command
Response operating command
Notification of Operation at NT600S to the Host
Host program NT600S operation
Receive notification
Notification operating command
Send notification command
Operation by Terminal Commands
The following describes control of the NT600S using the terminal commands.
For the actual procedure for using the terminal commands, refer to 7-4 Terminal
Commands (page 222).
The terminal commands allow the NT600S to be used as a terminal of the Host to
display text and graphics independently of the screens stored in the NT600S.
The Host sends a command and the NT600S processes the message. The
NT600S does not send back a response to the Host.
Host program NT600S operation
Message to PT
Terminal command
Process message