Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 34)

Note
Reference



  
 
Section 1-7
2-7 Before Operating
Follow the procedure given below to start the system of the NT600S.
When using Host Link/NT Link/RS-232C
PC NT600S Support tool
Check and change
the PC settings.

For the host link, refer
to page 31 and the
manuals for the host
link unit and peripheral
tools.
 For the NT link (1:1),
refer to page 43.
 For the NT link (1:N),
refer to page 47.
 No special setting re-
quired for C200H di-
rect communication
 For RS-232C:
Refer to page 63
Refer to the manuals
supplied with the Host.
Connect to the
NT600S.
Create the PC
program.
Set the DIP switches.
(page 26)
Install to the
operation panel.
(page 27)
Connect the power
supply.
(page 28)
Connect to the PC.
 (Host link: page 31)
 (NT link (1:1): page 43)
 (NT link (1:N): page 47)
 (C200H direct commu-
nication: page 56)
 (RS-232C: page 63)
Check the settings
and communications.
Transfer the
screen data.
(page 79)
Install support tools to
the computer.
(refer to Section 4 and the
manuals for the support
tools)
Create the screens.
Start operation.
Host
Check and change the
connection at the Host.
Create the Host
program.
(page 31)
Refer to the manuals
supplied with the Host.
Refer to Section 6.
Refer to the manuals
supplied with the Host.
Before starting actual operation, check the screen data and the program to be run
at the Host completely for its operation.
For usable support tools, refer to Appendix H Making the Cable for Connection to
the Support Tool (page 278)