3 connecting to the support tool – Omron NT-series Programmable Terminal V022-E3-1 User Manual

Page 44

Advertising
background image

Reference



      

Section 2-3

3-3

Connecting to the Support Tool

Connect the NT600S to a computer with an RS-232C cable to transfer the screen
data created by using a support tool to the NT600S.

In other than C200H direct communications, it is impossible to connect a computer
and the Host that are used to run the support tool at the same time. Connect a
computer only for transferring the screen data.



Communication conditions

Communication conditions are set when a support tool is started.



It is impossible to connect a computer and a PC/Host at the same time to the
NT600S. Connect a computer only to transfer the screen data.



To make a connector cable, refer to Appendix H Making the Cable for Connec-
tion to the Support Tool (page 278).

Advertising