Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 59)


    $    ' ( )*+*,
Section 2-5
3-5-3 PC Switch Settings
When the NT600S and PC are connected to each other, set the conditions at the
PC CPU so as to enable the NT link communications.
The following is a general description of switch settings.

C-series C200HS, C200HX/HG/HE, CPM1, CQM1
Set the operating conditions to the PC system setting area when a C200HS or
CQM1 CPU is connected to the NT600S. The PC system setting area (data
memory) can be directly accessed from the peripheral tool (LSS etc.).
The following describes the switch settings so as to enable the PC system set-
tings. For the details of the operation with the PC system setting area, refer to the
“SYSMAC CQM1 Reference Manual” (W228-E1-


).
[Switch setting] (C200HS, C200HX/HG/HE, CQM1)

RS-232C port communication
condition settings
Set DIP switch 5 to OFF (right side)
to enable the PC system settings.
CPU unit DIP switch settings
[PC system setting area settings] (C200HX/HG/HE, CPM1, CQM1)
Write values to the PC system setting area (data memory) in accordance with the
CPU unit and port used for connection to the NT600S.
PC Side Channel # Writing Value Settings
RS-232 port of
C200HX/HG/HE,
CQM1
DM6645
Port A of C200HX/
HG/HE
DM6555
4000 Use NT link (1:1)
Port B of C200HX/
HG/HE
DM6550
CPM1 DM6650