Quantum Data 881 - Manual (Page 1226)

AOZ Appendix C Error Messages
2124 Send GEN info error is not zero
The General infoframe register on the transmitter is not set to zero and the infoframe is not
transmitted. This typically means that there is a hardware problem in the HDMI board.
2125 Invalid sonic data
The value specified for the digital audio mixer (SDMG) is out of range.
2126 Invalid content aspect ratio
The value specified by the CXAR (content aspect ratio) parameter is invalid.
2128 Invalid audio contents
2129 Invalid signal aspect ratio
The value specified by the SXAR (signal aspect ratio) parameter is invalid.
2130 Horizontal active too small
The number of active pixels per horizontal scan line is less than the minimum supported
by the generator hardware configuration.
2140 Horizontal blanking too small
The video format’s horizontal blanking period expressed in microseconds and/or number
of pixel clock cycles is not supported by the generator hardware configuration.
2141 Horizontal blanking too small
Same as Error number 2140. Found in some firmware releases for different generator
hardware configurations.
2150 Horizontal blanking too small
Same as Error number 2140. Found in some firmware releases for different generator
hardware configurations.
2151 Horizontal total less than horizontal resolution
The video format’s total (active + blanked) number of pixel clock cycles per horizontal scan
line can not be less than the number of active pixels per scan line.
2152 Horizontal resolution too large or Horizontal blanking too small
Same as Error number 2140. Found in some firmware releases for different generator
hardware configurations.
2155 Horizontal blanking too small
Same as Error number 2140. Found in some firmware releases for different generator
hardware configurations.