Quantum Data 881 - Manual (Page 639)

881/882 Video Test Generator User Guide (Rev A.22) 621
5. To run 2C-04 tests using the short read with the encryption enable pulse positioned at
the end of the vsync pulse, enter the following commands:
CPTX:CRIP 0 // Specifies short read.
CPTX:OESS 2 // Positions the pulse at end of vsync.
CPTX:CPTR 19 // Selects specific test (e.g. 2C_04).
CPTX:CPTU // Initiates the execution of the test.
6. To run 2C-04 tests using the combined read with the encryption enable pulse
positioned at the beginning of the vsync pulse, enter the following commands:
CPTX:CRIP 1 // Specifies combined read.
CPTX:OESS 1 // Positions pulse at beginning of vsync.
CPTX:CPTR 19 // Selects specific test (e.g. 2C_04).
CPTX:CPTU // Initiates the execution of the test.
7. To run 2C-04 tests using the combined read with the encryption enable pulse
positioned at the center of the vsync pulse, enter the following commands:
CPTX:CRIP 1 // Specifies combined read.
CPTX:OESS 3 // Positions pulse at center of vsync.
CPTX:CPTR 19 // Selects specific test (e.g. 2C_04).
CPTX:CPTU // Initiates the execution of the test.
8. To run 2C-04 tests using the combined read with the encryption enable pulse
positioned at the end of the vsync pulse, enter the following commands:
CPTX:CRIP 1 // Specifies combined read.
CPTX:OESS 2 // Positions the pulse at end of vsync.
CPTX:CPTR 19 // Selects specific test (e.g. 2C_04).
CPTX:CPTU // Initiates the execution of the test.
Refer to “ To view the HDCP compliance report: ” on page 651 for procedures on how to
view the generated report.