Quantum Data 881 - Manual (Page 612)

594 Chapter 18 Testing HDCP
Running HDCP test in step mode
The generator normally runs the steps in the HDCP test automatically. However, to
troubleshoot a failed test, you can run the test in “step” mode. This enables you to read the
values at the step where the test failed.
To run the HDCP test in step mode:
1. Connect a cable between the HDMI or DisplayPort OUT connector on the generator
and the device’s input.
2. Activate the HDMI-H, HDMI-D or DisplayPort interface on the output port as follows:
a. Press the Interface key. A listing of signal interfaces appears on the generator’s
display as shown below.
b. Choose either the HDMI-H, HDMI-D or DisplayPort item by pressing the adjacent
soft key. The interface is activated, and the port outputs the currently selected
image and format.
Alternatively, to activate the interface through the command line interface, enter the
following commands:
XVSI 4 // Activates the HDMI-H interface
(3 for HDMI-D or 10 for DisplayPort)
ALLU // Applies the interface setting to the generator
3. Press the Content key and choose the HdcpProd image by pressing the adjacent soft
key. Or, if you are using HDMI OUT port 2, choose the HDCP2 test image.
VGA
HDMI-D CVBS
S-VIDEO
SDI
*
HDMI-H