Quantum Data 881 User Manual
Page 659
881/882 Video Test Generator User Guide
(Rev A.22)
641
CPTX:DUTT 4
// specifies the device under test as a repeater
for the 3C test.
You can query the current value of the parameter with:
CPTX:DUTT?
// returns the device under test type.
10. (Optional) Specify the remaining parameters in the
EditPCP menu using the table
above.
Alternatively, you can specify the parameters through the command line as follows:
CPTX:RPFT 0
// indicates whether DUT (repeater) supports 1.1
features such as Advanced Cipher and Enhanced
Link Verification. 1 = yes; 0 = no.
CPTX:RKSV 10
// specifies maximum number of downstream devices
that can be supported in the repeater’s KSV list
CPTX:ROOR 0
// indicates whether DUT (repeater) outputs outputs
content to the downstream repeater that does not
have any downstream device connected.
1 = yes; 0 = no.
11. Press the
Options key to save the capabilities definition.
The generator LCD will display the message “Saved”.
12. Press the
Tools key get back to the Reports menu.
The generator LCD will display the reports menu as shown below.
13. Select
HDCP to access the HDCP compliance test menu.
The following is displayed on the generator’s LCD.
14. Select
!CompRpt to initiate the HDCP compliance test.
The message “HDCP Compliance Test” is shown and then all the tests are shown in
sequence.
Alternatively, you can run the tests using the following command:
CPTX:CPTR 46
// specifies that all applicable tests will be run.
CPTX:CPTU
// Initiates the execution of the test
Refer to “
To view the HDCP compliance report:
” on page 651 for procedures on how to
view the generated report.
15. (Optional) To run a specific test you can use the command line as shown below:
EDID
Packets
Misc
HDCP
!CompRpt
EditPCP