Teledyne 300M - Manual (Page 31)

Teledyne API Model 300M CO Analyzer Instruction Manual, 04033, Rev. A
Table 2-2: System Modes
Mode Meaning
SAMPLE x (1) Sampling normally
SAMPLE x (1) Flashing indicates adaptive filter is on
ZERO CAL x (2) Doing a zero check or adjust
SPAN CAL x (2) Doing a span check or adjust
MP CAL Doing a multi-point calibration
SETUP xxx (3) Configuring analyzer (sampling continues)
DIAG DAS (4) Data Acquisition configuration
DIAG I/O (4) Test digital I/O signals
DIAG AOUT (4) Test analog output channels
DIAG D/A (4) Configure and Calibrate Digital to Analog converters
DIAG TCHN (4) Configure Test Channel output
(1) x = A (auto)
(2) x = M (manual), A (auto), R (remote)
(3) xxx = software revision (e.g. A.9)
(4) diagnostic test modes
The message field shows test measurements or warning messages. Table 2-3 and Table 2-4
summarize the test measurements and warning messages and their meanings. Refer to Sections 4
and 5 for detailed information on viewing test measurements and warning messages and clearing
warnings.
2-5