Teledyne 300M - Manual (Page 72)

Teledyne API Model 300M CO Analyzer Instruction Manual, 04033, Rev. A
7.3 Status/Control
This subset of messages is concerned with reporting the status of the analyzer and controlling the
analyzer remotely. Whenever the analyzer does a calibration it issues a report to the RS-232
output. The table on the following page summarizes the status reports.
Table 7-4: Status Reports
Report
"C DDD:HH:MM IIII START ZERO CALIBRATION"
"C DDD:HH:MM IIII FINISH ZERO CALIBRATION"
"C DDD:HH:MM IIII START SPAN CALIBRATION"
"C DDD:HH:MM IIII FINISH SPAN CALIBRATION"
"C DDD:HH:MM IIII START MULTI-POINT CALIBRATION"
"C DDD:HH:MM IIII FINISH MULTI-POINT CALIBRATION"
"C DDD:HH:MM IIII START CALIBRATION HOLD"
"C DDD:HH:MM IIII FINISH CALIBRATION HOLD"
To do a remote adjustment via the RS-232 interface, the host computer should issue a message
with the following format:
C COMMAND<CRLF>
The commands are summarized in Table 7-5.
7-6