Cobalt Digital FUSION 3G 9901-UDX 3G_HD_SD Up Down_Cross Converter - Manual (Page 42)

2
Installing a Rear Module
2-4 9901-UDX PRODUCT MANUAL 9901-UDX-OM (V1.15)
10. If network remote control is to be used for the frame and the frame has
not yet been set up for remote control, perform setup in accordance with
Setting Up 9901-UDX Network Remote Control (p. 2-15).
Note: If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
Installing a Rear Module
Notes: • This procedure is applicable only if a Rear Module is not currently
installed in the slot where the 9901-UDX is to be installed.
• Where options are furnished using a piggyback card mounted to 9901-UDX
main card, base Rear Module must be installed in frame location such that
Rear Module interfaces with base card. Expansion Rear Module must be
installed in frame location such that Rear Module interfaces with expansion
(piggyback) card (see Figure 2-3).
• Note that some Rear Modules and labels have several ventilation holes. To
allow maximum ventilation, it is recommended to place the label fully over
connectors such that label is flush with rear module and holes are not
obscured. Also, when a card is not installed in a slot, it is recommended that
the supplied blank cover be used to preserve proper forced ventilation
flow-through.
The full assortment of 9901-UDX Rear Modules is shown and described in
9901-UDX Rear Modules (p. 2-7). Install a Rear Module as follows:
1. On the frame, determine the slot in which the 9901-UDX is to be
installed.
2. In the mounting area corresponding to the slot location, install
Rear Module as shown in Figure 2-2.
3. If an expansion Rear Module is to be installed, install it adjacent to the
base Rear Module as shown in Figure 2-3.