Cobalt Digital FUSION 3G 9901-UDX 3G_HD_SD Up Down_Cross Converter - Manual (Page 97)

9901-UDX-OM (V1.15) 9901-UDX PRODUCT MANUAL 3-43
Operating Instructions
9901-UDX Function Submenu List and Descriptions
Output Audio Routing/Controls
Provides controls to route card audio from card
processing paths to outgoing embedded and AES audio
destinations. Use the corresponding sub-tab to access
embedded or AES output routing.
Table 3-2 9901-UDX Function Submenu List — continued
The card internal bus, upmix/loudness processing
outputs, and the Dolby encoder output pair are
available as sources for the card embedded audio
and AES audio outputs.
The example here shows various Source routing
selections (using the Emb Audio Out and AES
Audio Out sub-tabs) that direct upmix outputs L thru
Rs to Embedded outputs Ch 1 thru Ch 6, the
pre-upmix Bus Ch1 and Ch 2 sources to Embedded
outputs Ch 7 and Ch 8, and a Dolby encoded pair to
AES outputs Ch 1 and Ch 2 (unused embedded and
AES channels can be set to Silence or Mute).
Each bus channel provides Gain, Mute, and a peak
level display.
The source-to-destination correlation shown here is
only an example; any of the digital audio output
destinations described on the following pages can
receive inputs from any of the internal bus, DSP, or
Dolby encoder sources.
Embed Out
Ch 7, Ch 8
AES Out
Ch 1, Ch 2
Output Audio
Crosspoint
Card 16-Ch Internal Bus
Audio
DSP
Dolby ®
AC-3
Encode
Bus Ch 1, 2
Upmix L thru Rs Embed Out
Ch 1 - Ch 6
Dolby ENC