Cobalt Digital FUSION 3G 9901-UDX 3G_HD_SD Up Down_Cross Converter - Manual (Page 86)

3
9901-UDX Function Submenu List and Descriptions
3-32 9901-UDX PRODUCT MANUAL 9901-UDX-OM (V1.15)
Input Audio Status
Displays signal status and payload for embedded and
discrete audio received by the card.
Individual signal status and peak level displays for embedded audio input pairs, and AES/analog input pairs (where licensed) as
described below. AES pair status also shows sample rate.
• Unlocked: Indicates AES pair or embedded channel does not contain recognized audio PCM data.
• PCM: Indicates AES pair or embedded channel contains recognized AES audio PCM data.
• Dolby E: Indicates AES pair or embedded channel contains Dolby ® E encoded data.
• Dolby Digital: Indicates AES pair or embedded channel contains Dolby ® Digital encoded data.
Note: • Dolby status displays occur only for valid Dolby ® signals meeting SMPTE 337M standard. If a Dolby pair is passed
through the card without decoding, the signal is passed with all related gain controls locked out.
• AES Dolby-encoded inputs that are routed directly to card optional Dolby decoder are detected as Dolby and are
then routed via a special path that automatically bypasses SRC. However, AES inputs to other destinations (e.g.,
AES embedding) are first applied through SRC. These paths disable SRC if Dolby-encoded data is detected. To
avoid a possible “Dolby noise burst” if an input on these paths changes from PCM to Dolby, it is recommended to set
the AES SRC control for the pair to SCR Off for an AES input that is expected to carry a Dolby signal.
• With SRC set to Off when receiving a PCM pair over an AES input, Status may display “NULL code 0, Line 0” or
“Data” instead of the expected “PCM” message. The Peak field may also display “Data” instead of the dBFS levels
for the pair. This issue is related only to the DashBoard display; the processing, control, and passthrough of PCM
AES pairs is not affected in any way by this issue.
Note: After familiarizing yourself with the controls described in the audio routing/control sections that follow, see “Audio
Routing with GPI Control Example” (p. 3-59) for a comprehensive example using these controls for multi-source audio
routing.
Table 3-2 9901-UDX Function Submenu List — continued