Cobalt Digital FUSION 3G 9901-UDX 3G_HD_SD Up Down_Cross Converter - Manual (Page 8)

1
Safety Summary
1-4 9901-UDX PRODUCT MANUAL 9901-UDX-OM (V1.15)
Labeling Symbol Definitions
Safety Summary
Warnings
Cautions
Attention, consult accompanying documents.
Electronic device or assembly is susceptible to damage from an ESD event.
Handle only using appropriate ESD prevention practices.
If ESD wrist strap is not available, handle card only by edges and avoid contact
with any connectors or components.
Symbol (WEEE 2002/96/EC)
For product disposal, ensure the following:
• Do not dispose of this product as unsorted municipal waste.
• Collect this product separately.
• Use collection and return systems available to you.
! WARNING !
To reduce risk of electric shock do not remove line voltage service barrier cover on frame
equipment containing an AC power supply. NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
! WARNING !
Adhere to GPO port maximum voltage/current limits. This port is specified for
low-voltage/low-current control circuits only. Using this port for any other purpose may
result in an unsafe condition and can damage the card.
CLASS 1 LASER PRODUCT - IEC 60825-1:2007. Never look into fiber connector or cable
end of device transmitting an optical signal. The transmitted light is not visible and can
cause permanent eye damage. Do not perform connection/disconnection with sending or
receiving device powered.
CAUTION
This device is intended for environmentally controlled use only in appropriate video
terminal equipment operating environments.
CAUTION
This product is intended to be a component product of an openGear ® frame. Refer to the
openGear
®
frame Owner's Manual for important safety instructions regarding the proper
installation and safe operation of the frame as well as its component products.
CAUTION
Heat and power distribution requirements within a frame may dictate specific slot
placement of cards. Cards with many heat-producing components should be arranged to
avoid areas of excess heat build-up, particularly in frames using only convection cooling.
The 9901-UDX has a moderate power dissipation (30 W max.). As such, avoiding placing
the card adjacent to other cards with similar dissipation values if possible.
CAUTION
If required, make certain Rear Module(s) is installed before installing the 9901-UDX into
the frame slot. Damage to card and/or Rear Module can occur if module installation is
attempted with card already installed in slot.
CAUTION
If card resists fully engaging in Rear Module mating connector, check for alignment and
proper insertion in slot tracks. Damage to card and/or Rear Module may occur if improper
card insertion is attempted.