GE Industrial Solutions NEMA EVSE CHARGING STATION - Manual (Page 10)

g
EV Charging Station User Manual & Installation Instructions
GE EV Charging Station User Manual 10 of 86
Open the door by pressing the round button on the door latch. Insert the Kiosk from top and install ½-
13 nuts and star washers after lowering skirt over matching threaded rods as shown in the Figures 6
and 7.
Torque all the nuts as per the torque specification in Table 1 (recommended tool: 3/8” drive quick
release ratchet & 13/16 socket).
Connect L1 and L2 to the fuse block and ground wire to the ground bar shown in Figure 8.
IMPORTANT: EV Charging Station is rated for 208-240V power only. The EVSE must be connected to a
grounded, metal, permanent wiring system, or an equipment grounding conductor. This should be run
with circuit conductors and connected to the equipment grounding bar or lead on the EVSE.
Connections to the EVSE shall comply with all applicable electrical codes and ordinances.
In case of RFID sensor, the communication cable is connected to the Ethernet connector on the
controller as shown in Figure 9.
½-13 NUT AND ½”
STAR WASHER
CONCRETE LEVEL
Figure 6 Figure 7