GE Industrial Solutions NEMA EVSE CHARGING STATION - Manual (Page 3)

g
EV Charging Station User Manual & Installation Instructions
GE EV Charging Station User Manual 3 of 86
1 Important Safety and Grounding Instructions
1.1 Safety and Compliance
WARNING:
Read all the instructions before using this product.
This device should be supervised when used around children.
Do not put fingers into the electric vehicle connector.
Do not use this product if the flexible power cord or EV cable are frayed, have broken insulation, or
any other signs of damage.
Do not use this product if the enclosure or the EV connector are broken, cracked, open, or show any
other indication of damage.
This document provides instructions for installation of EV Charging Station products listed in Table 11
in Section 3.3, and should not be used for any other product. Before installing the EVSE (Electric
Vehicle Supply Equipment), you should review this manual carefully and consult with a licensed
contractor, licensed electrician, or trained installation expert to ensure compliance with local building
codes, climate conditions, safety standards and state and local electrical codes.
The EVSE should be installed only by a licensed contractor, and/or a licensed electrician in accordance
with all applicable state, local and national electrical codes and standards. The EVSE should be
inspected by a qualified installer prior to initial use. Under no circumstances will compliance with the
information in this manual relieve the user of his/her responsibility to comply with all applicable codes
or safety standards.
1.2 Grounding Instructions
The EVSE must be connected to a grounded, metal, permanent wiring system, or an equipment
grounding conductor. This should be run with circuit conductors and connected to the equipment
grounding bar or lead on the EVSE. Connections to the EVSE shall comply with all applicable electrical
codes and ordinances.