GE Industrial Solutions NEMA EVSE CHARGING STATION - Manual (Page 40)

g
EV Charging Station User Manual & Installation Instructions
GE EV Charging Station User Manual 40 of 86
Once the hardware installation is complete, refer to the software installation guide provided with the
RFID package.
2.9.2 VFD
This section describes how to install the VFD for Pedestal, Wall Mounted and Pole Mounted EVSE units
only. For the Back to Back EVSE unit VFD replacement, contact a GE representative by calling 1-
800-GE1STOP.
Open the service door and remove the VFD wire harness from the VFD as shown in Figure 43.
If RFID has been provided, remove the RFID wire harness from the socket on the controller as shown
in Figures 41 and 42.
Next, remove the VFD/RFID mounting assembly by removing the eight 10/32” nuts as shown in Figure
44.
Figure 43: Harness Connection to VFD
WARNING: Make sure power to the EVSE is
disconnected before performing any task