Ev charging station, User manual & installation instructions – GE Industrial Solutions NEMA EVSE CHARGING STATION User Manual

Page 75

Advertising
background image

g

EV Charging Station

User Manual & Installation Instructions

GE EV Charging Station User Manual

75 of 86

Default Gateway
See above

Fan wired with contactor
EVSE owners with indoor installations who want to charge vehicles that require facility fans to
be turned on must run signal connections to terminals 4 and 5 of the Power Terminal Block
(PTB). The EVSE owner must follow electrical codes to ensure that proper ventilation is
allocated for their facility.

Non-compliant SAEJ1772 behavior
Some earlier EV models equipped with a retrofit kit have a Pilot signal feedback that does not
comply with the SAE-J1772 / IEC 61851 standard. By default, this option is not enabled. Should
there be cars with retrofit kits to use this EVSE, check this box.

After a power loss enable a random delay before charging resumes

If there is a large number of EVSE on a local feed, consider setting this box to enable a gradual
increase in load on resumption of power.

Require Authorization for charging.
RFID authentication requires this check box to be checked on all EVSE in the network.

Host IP address

By default, the IP address is set to 192.168.2.19, and needs to be changed to one of the
following options, depending on which address range to use:
- 172.25.1.100 in case of the EVSE IP range being 172.25.0.xx
- 172.26.1.100 in case of the EVSE IP range being 172.26.0.xx

TCP Host Port & TCP Source Port.
Change the value to 9500 for both the Host and Source Port to match the default value fo the
EV100 Application SW. Unless there is a collision by using this Port on the host PC, it is

Note: Make sure the Host PC is configured according to the same IP address settings as
entered in the EVSE configuration server page.

Note: In the case of any modification of the “Require authentication for charging”
status, or after a reset or replacement of the controller, the Station ID must be modified

to a new ID not previously used on this network to avoid transaction data to be lost.

Action
required !

Action
required !

Action
required !

Advertising