GE Industrial Solutions NEMA EVSE CHARGING STATION - Manual (Page 81)

g
EV Charging Station User Manual & Installation Instructions
GE EV Charging Station User Manual 81 of 86
2. Launch the EV100 Application
Start the EV100 Application and log in. Default login is “admin” and the password “admin”.
You should now see the stations appear in the list with a green status after at most 5 min.
After at most 5min, all EVSE in the network should appear in the list. Check that all EVSE are present
and listed with their correctly configured Station ID.
Should one of the EVSE not appear in the list, power that station down and up again.
Click on “Home” to refresh the screen at any time.
3. Enroll drivers
In order to enroll new drivers, follow these steps or detail instructions included in the Help>Add
driver section
- Plug in the enrollment card reader (accessory from GE, cat # EVRP01) into the USB port
- Wait for the USB driver installation to successfully complete
- Click on “Add” to open the Add New Driver dialog box
- Click on “OK” then hold the RFID card of the new user in front of the enrolment reader for a
few seconds. You should see a change in the LED on the reader itself and a hexadecimal
number appear in the text field.
- Fill in the remaining information.
- Add more drivers to the list. For more information, refer to the SW user manual or the help
file.
- You can close the application EV100, but keep the host PC connected and up and running at
all times for the RFID authentication to work.
4. Check driver registration
Any driver with a registered RFID card can now use the connected EVSE.
Note: If the keyboard is set to French or Belgium keep the CAPSLOCK ON during card ID
registration. Should the output of the reader in the text field include characters other than 0-
9 and A-F, set the keyboard settings of Windows to “US English”.
Note: ”Users” are user accounts for the EV100 application with associated login and
password. “Drivers” are EV drivers and are enrolled for usage of the EVSE infrastructure
and identify themselves with RFID cards.
Note: A change of the Host PC IP address while the listener service is running requires a
restart of the listener service or a reboot of the host PC. For detail instructions reach out
to User Manual document included on CD 1.