GE Industrial Solutions NEMA EVSE CHARGING STATION User Manual
Page 14
g
EV Charging Station
User Manual & Installation Instructions
GE EV Charging Station User Manual
14 of 86
Locate area for pedestal location
Locate area for double pedestal location.
Install conduits for power wire and communication wire (if required). Allow approximately 5” length for
each conduit above the concrete level as shown in Figure 13. Cut as necessary to final dimensions.
Route power conduit and communication conduit through the center of the hole in the mounting
template, appropriately.
Install base mounting assembly plate securely over conduits with mounting template and four 1/2-13
nuts.
WARNING: Make sure power to the EVSE is
disconnected before performing any task
CONDUIT
MOUNTING TEMPLATE
BASE MOUNTING
ASSEMBLY
CONCRETE
Figure 11
Figure 12