GE Industrial Solutions NEMA EVSE CHARGING STATION - Manual (Page 70)

g
EV Charging Station User Manual & Installation Instructions
GE EV Charging Station User Manual 70 of 86
After the desired settings were configured click on “Save”.
Repeat this procedure for all EVSE in the network.
Host PC Settings
In order to set up your Host PC, make sure you have full Windows Administrator rights.
Disable any firewalls and all other Ethernet and WiFi connections on this PC.
Then follow these steps to configure your TCP/IP settings for communication with the EVSE during
setup.
The NIC on the host PC should be connected to the Charging Station Network Ethernet Switch.
Note: The Station ID information is how the EV100 application distinguishes between
stations in the same network. Make sure you assign different values to each EVSE.
Note: In the case of any modification of the “Require authentication for charging”
status, or after a reset or replacement of the controller, the Station ID must be modified
to a new ID not previously used on this network to avoid transaction data to be lost.
Figure 66