CognitiveTPG DLXi - Manual (Page 42)

S T A N D A R D P R I N T E R C O M M A N D S
cell size
Sets size of module (square) in the
barcode in 100ths of an inch. Value
specified can be decimal (see first
example below). Values are between
1.0 and 10.0, blank indicates a
default of 2.
bytes Number of encoded data bytes,
including carriage returns and line
feeds, or delim which indicates a
delimiter used to mark the data start
and end (see Example).
Leave blank for the encoder to
determine the byte count. The
encoder will stop at the first newline
sequence.
x y X and Y starting position for bar code
block.
data Data to be encoded. Data must start
on a new line, separated from the
command by a newline sequence.
NOTE: The number of bytes specified
must exactly equal the number of
bytes in the data that follows. The
printer may not execute other
commands following the
BARCODE
DATA_MATRIX co mmand if the byte
value is incorrect.
Revision F, January 2012, CognitiveTPG 33