Replacing an sfp+ transceiver – Brocade DCX 8510-8 Backbone Hardware Reference Manual User Manual
Page 103
blade. Refer to the illustration for the mSFP transceiver for the basic appearance of the 16 Gbps
transceiver.
FIGURE 30 Replacing an optical transceiver
1. SFP/XFP bail
FIGURE 31 Replacing a 16 Gbps SFP+ optical transceiver
Replacing an SFP+ transceiver
Complete the following steps to replace an SFP+ transceiver.
1. Making sure that the bail (wire handle) is in the unlocked position, position the optical transceiver so
that the key is oriented correctly to the port. Insert the transceiver into the port until it is firmly seated
and the latching mechanism clicks; then close the bail.
The 16 Gbps SFP+ transceivers do not have bails. Use the tab on the 16 Gbps SFP+ transceivers to
help gently push the transceiver into the port. Do not push so hard as to bend the tab.
Replacing an SFP+ transceiver
Brocade DCX 8510-8 Backbone Hardware Reference Manual
103
53-1002180-07