Brocade DCX 8510-8 Backbone Hardware Reference Manual - Manual (Page 73)

Removal and Replacement Procedures
● Introduction..................................................................................................................... 73
● ESD precautions............................................................................................................. 73
● Chassis door removal and replacement..........................................................................74
● Cable management comb removal and replacement..................................................... 75
● Port, application, and encryption blade removal and replacement................................. 76
● Blade filler panel removal and replacement.................................................................... 80
● Control processor blade (CP8) removal and replacement.............................................. 82
● Core switch blade (CR16-8) removal and replacement.................................................. 90
● Power supply removal and replacement......................................................................... 93
● Blower assembly removal and replacement................................................................... 96
● WWN card removal and replacement............................................................................. 97
● Transceiver removal and replacement..........................................................................101
● Inter-chassis link (ICL) cable removal and replacement............................................... 106
● Brocade DCX 8510-8 chassis removal and replacement............................................. 111
Introduction
NOTE
Read the safety notices before servicing
Caution and Danger Notices .
The field-replaceable units (FRUs) in the Brocade DCX 8510-8 can be removed and replaced without
special tools. The Brocade DCX 8510-8 can continue operating during many of the FRU replacements if
the conditions specified in the procedures are followed.
The following sections contain FRU removal and replacement procedures (RRPs).
ESD precautions
The Brocade DCX 8510-8 contains ESD-sensitive FRUs. When working with any Brocade DCX 8510-8
FRU, use correct electrostatic discharge (ESD) procedures.
• Wear a wrist grounding strap connected to chassis ground (if the Brocade DCX 8510-8 is plugged in)
or a bench ground.
• Store ESD-sensitive components in antistatic packaging.
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
CAUTION
Static electricity can damage the chassis and other electronic devices. To avoid damage, keep
static-sensitive devices in their static-protective packages until you are ready to install them.
Brocade DCX 8510-8 Backbone Hardware Reference Manual 73
53-1002180-07