Brocade DCX 8510-8 Backbone Hardware Reference Manual - Manual (Page 47)

Monitoring System Components
● Monitoring overview........................................................................................................ 47
● Determining the status of a port or application blade......................................................52
● Determining the status of a control processor blade (CP8)............................................ 63
● Determining the status of a core switch blade (CR16-8).................................................65
● Determining the status of a power supply....................................................................... 67
● Determining the status of a blower assembly................................................................. 68
● Determining the status of a WWN card...........................................................................70
Monitoring overview
The Brocade DCX 8510-8 is engineered for reliability and requires no routine operational steps or
maintenance. This chapter provides information about determining the status of each component using
LEDs and CLI commands. Refer to theWeb Tools Administrator's Guide and the Fabric OS
Administrator's Guide for additional information.
There are two commands that can be especially helpful in monitoring the health of the Brocade DCX
8510-8. These commands are switchShow and chassisShow.
Note in the switchShow command the new switchType for the Brocade DCX 8510-8 as well as the 16-
Gbps speed identification for capable ports. The output has been truncated to reduce information
duplication.
DCX_8510_8:admin> switchshow
switchName: DCX_8510_8
switchType: 120.3
switchState: Online
switchMode: Native
switchRole: Subordinate
switchDomain: 120
switchId: fffc78
switchWwn: 10:00:00:05:1e:d2:64:00
zoning: ON (BB)
switchBeacon: OFF
FC Router: ON
FC Router BB Fabric ID: 10
Address Mode: 0
Index Slot Port Address Media Speed State Proto
=======================================================
0 1 0 780000 id N8 No_Light FC Disabled (Switch not ready for
EX_Ports)
1 1 1 780100 id N8 No_Light FC Disabled (Switch not ready for
EX_Ports)
2 1 2 780200 -- N8 No_Module FC Disabled (Switch not ready for
EX_Ports)
3 1 3 780300 -- N8 No_Module FC Disabled (Switch not ready for
EX_Ports)
4 1 4 780400 id N8 No_Light FC Disabled (Switch not ready for
EX_Ports)
5 1 5 780500 id N8 No_Light FC Disabled (Switch not ready for
EX_Ports)
6 1 6 780600 id N8 No_Light FC
7 1 7 780700 id 4G No_Light FC
8 1 8 780800 -- N8 No_Module FC
9 1 9 780900 -- N8 No_Module FC
10 1 10 780a00 -- N8 No_Module FC
11 1 11 780b00 -- N8 No_Module FC
Brocade DCX 8510-8 Backbone Hardware Reference Manual 47
53-1002180-07