Replacing a blade – Brocade DCX 8510-8 Backbone Hardware Reference Manual User Manual
Page 79
Advertising
11.Open the ejectors by rotating them toward the center of the blade face. Pull the blade out of the
chassis using the ejectors.
12.If the blade is not being replaced by another blade, install a filler panel.
FIGURE 21 Removal and replacement of the port, application, and encryption blades (FC16-48 port
blade shown)
Replacing a blade
Complete this procedure to replace a blade.
Follow electrostatic discharge (ESD) precautions when replacing a blade. Wear a wrist grounding strap
connected to chassis ground (if the Brocade DCX 8510-8 is plugged in) or a bench ground.
Replacing a blade
Brocade DCX 8510-8 Backbone Hardware Reference Manual
79
53-1002180-07
Advertising