Replacing a power supply – Brocade DCX 8510-8 Backbone Hardware Reference Manual User Manual
Page 95
Advertising
FIGURE 26 Removal and replacement of the power supply
Replacing a power supply
To replace a power supply, complete the following steps.
1. If you are not replacing the power supply, insert a filler panel into the slot.
2. Otherwise, insert the power supply into the slot. Verify that the power supply is seated by gently
pulling on the handle.
3. Tighten the thumbscrew.
4. Replace the power cord.
5. Latch the power cord retainer clip.
6. Turn on the power switch.
Replacing a power supply
Brocade DCX 8510-8 Backbone Hardware Reference Manual
95
53-1002180-07
Advertising