Brocade DCX 8510-4 Backbone Hardware Reference Manual - Manual (Page 83)

FIGURE 27 Removal and replacement of the blower assembly
Replacing a blower assembly
Complete the following steps to replace the blower assembly in a chassis.
1. Orient the blower assembly and slide it into the chassis, pushing firmly to ensure that it is seated.
2. Verify that the power LED displays a green light.
3. Use the screwdriver or your fingers to tighten the captive screws.
WWN card removal and replacement
There are two WWN cards located beneath the WWN bezel (logo plate). Use this procedure to remove
and replace the WWN cards. If Brocade Support has determined that a WWN card needs to be
replaced, you need to power-down the chassis, and then both the WWN cards must be replaced as a
matched pair.
Replacing a blower assembly
Brocade DCX 8510-4 Backbone Hardware Reference Manual 83
53-1002177-07