Spectra Precision Survey Pro v3.80 Recon iPAQ User Manual - Manual (Page 36)

User’s Manual
28
Stakeout Settings
The Stakeout Settings contains the setting that control how stakeout
is performed.
Stake “Corners,” Not Just Even Intervals : when staking
by stations, locations where a line segment changes,
such as from a straight section to a curve, will also be
staked when this is checked.
Always Start Stakeout With Coarse Mode : when
checked, the Coarse EDM (fast shot) checkbox found in all
stakeout screens will initially be checked. This instructs
the total station to measure distances faster, but with
slightly less accuracy.
Use Manual Updating (Remote Control) : When this is
checked, an
8SGDWH button in the stakeout screens must
be pressed to take a shot. When this not checked, shots
are continuously taken in the stakeout screens. (This is
only valid when running in remote mode using a robotic
total station.)
; Design Elevation from Offset Segment : When checked during
offset or road stakeout, cut and fill information will be computed from
the design elevation at the node furthest from the centerline of the
current segment. When unchecked, cut and fill information will be
computed from the design elevation of the segment at the current rod
location.
Note: If staking extends beyond the end of the cross section, the cut /
fill information will always be computed from the design elevation at
the node furthest from the centerline of the current segment.
;
Write Cut Sheet Data Only (no store point) : When checked, as-
built points are not stored to the JOB file when staking points; only
the raw data is written to the RAW file.
;
Display Left / Right From Rod (non-remote) : When checked, the
move left or right information will be presented from the rod person’s
point of view. When unchecked it will be presented from the total