Spectra Precision Survey Pro v3.80 Recon iPAQ User Manual - Manual (Page 81)

Fieldwork
73
the next available point name and the information from the
last shot is displayed on the screen.
d. You can see a graphical representation of the
previous shot by tapping the
Map tab. See
Page 21 for more information on the Map View.
Performing a Traverse Shot
6. The steps involved in performing a side shot are
nearly identical to performing a traverse shot. The
difference is you must specify if you plan to move
the total station to the current foresight point after
the shot is taken.
a. Tap the ,QSXW tab of the Traverse / Sideshot.
The Foresight point should now be updated to
4 .
b. Assuming that you are now aiming the total
station at a prism located over the foresight
point, tap
7UDYHUVH . This would trigger the
total station to take a shot, compute
coordinates for the new point and store it.
Since we are running in manual mode, we will
enter the shot data from the keypad.
c. Enter the following data:
Angle Right : 45
Zenith : 90
Slope Dist : 50 and then tap OK.