Spectra Precision Survey Pro v3.80 Recon iPAQ User Manual - Manual (Page 88)

User’s Manual
80
g. Assuming the rod has been repositioned, take another shot by
tapping the
6KRW  button and enter the following new shot
data:
Angle Right : 45
Zenith Angle : 90
Slope Dist : 70.8 and then tap OK to continue.
h. The rod must now move FORWARD by 0.089 feet
to be over the design point. We will assume that
this is close enough and will store the point from
this shot by tapping the
6WRUH« button.
i. Enter the following point information:
Point Name : 5
Description : Staked and tap 6WRUH . This will
return you to the first Point Stake screen.
5. Stake the next design point.
a. We want to stake the next design point in the
project. We can do this by entering
3 in the Design
Point field and then pressing 6ROYH ! , or we can
simply tap 1H[W 3RLQW ! , which will automatically
advance the current design point by the increment
value and solve automatically. Either method will
send you to the second Stake Points screen.
b. The information needed to locate the next design
point is displayed. When connected to a total
station, you would turn the total station
horizontally to 115°00’00”, vertically to 90°00’00”
and send the rod man out about 100 feet before
continuing. Tap the
 6WDNH !  button to continue
to the third screen.
c. Tap the 6KRW button and enter the following shot data:
Angle Right : 115
Zenith : 90
Slope Dist : 99.8 and then tap OK to continue.