Spectra Precision Survey Pro v3.80 Recon iPAQ User Manual - Manual (Page 38)

User’s Manual
30
•
Cut Sheet and Points : When a stake point is stored, cut / fill
data is stored to the current raw data file and the point
coordinates are stored in the current job.
•
Cut Sheet only : When a stake point is stored, only cut / fill
data for that point is stored to the current raw data file.
(Point coordinates are not stored.)
•
Points only : When a stake point is stored, only the point
coordinates are stored in the current job. (Cut / fill data is not
stored.)
Cut Sheet Offset stored : The cut sheet offset information can be
stored to the raw data file in either of the following formats when
performing any offset staking routine:
•
Design Offset : when selected, a cut sheet report will list the
design-offset values.
•
Actual Offset : when selected, a cut sheet report will list the
measured-offset values.
Repetition Settings
The Repetition Settings contains the settings that control how
repetition shots are performed and the acceptable tolerances.
Horizontal Tolerance : a warning message will be
displayed if a horizontal angle exceeds the tolerance
entered here during a repetition shot.
Zenith Tolerance : a warning message will be displayed if
a vertical angle exceeds the tolerance entered here
during a repetition shot.
Distance Tolerance : a warning message will be
displayed if a distance exceeds the tolerance entered
here during a repetition shot.
Shoot Distance To Backsight : when checked, a distance
will be measured to each shot to the backsight. When
unchecked, only the angles are measured.
Do Not Shoot Reverse Distances : when checked,