Spectra Precision Survey Pro v3.80 Recon iPAQ User Manual - Manual (Page 85)

Fieldwork
77
Set Up
1. Open the job that was created in the Traverse / Side Shot
Example.
a. From the Main Menu, select )LOH , 2SHQ  1HZ to open the
Open / New screen.
b. Tap the file name that was created earlier
listed in the
Open Recent Job list and then tap
 2SHQ . The coordinates for that job are shown
here.
2. Set the job settings. (Only the settings that affect
this example are covered here.)
a. Select -RE , 6HWWLQJV from the Main Menu.
b. Tap the Instrument tab and set both the Brand
and Model fields to Manual Mode .
c. Tap the Surveying tab and confirm that all of
the checkboxes are unchecked.
d. Tap the Stakeout tab and make sure the final
field ( Cut Sheet Offset Stored) is set to Actual
Offset .
Note: When performing stakeout, you have the option of storing cut
sheet information. This information is stored in the raw data file,
and when using software on a PC, such as Survey Link, it can be
extracted in the form of a Cut Sheet Report.
e. Tap OK to save the job settings.
3. Setup your backsight. In this example, we will setup on Point 1
and backsight an object where it is assumed that the direction to
that object is known. When connected to a total station, you
would setup over your occupy point, aim toward the backsight
and zero the horizontal angle in the total station before
continuing.
a. Access the
6XUYH\ , %DFNVLJKW 6HWXS screen.