Spectra Precision Survey Pro v3.80 Recon iPAQ User Manual - Manual (Page 80)

User’s Manual
72
g. Tap 6ROYH . The Map screen will open
automatically.
h. Tap &ORVH to continue.
Performing a Side Shot
5. Access the 6XUYH\ , 7UDYHUVH  6LGHVKRW screen and
fill in the appropriate fields. The backsight
information is displayed in the lower portion of the
screen. At this point, it is assumed that your total
station is over the occupy point and its horizontal
angle was zeroed while aiming toward the backsight.
a. In the Traverse / Sideshot screen, enter the
following data:
Foresight : 3
Description : SS
HR : 5
These values will define the point name,
description, and rod height for the next point
that is stored.
b. Assuming that the total station is aiming toward
the prism, which is located over the foresight, tap
6LGH 6KRW . In the field, this would trigger the total station to
take a shot, compute coordinates for the new point and store
it. Since we are running in manual mode, we will enter the
shot data from the keypad.
c. Enter the following data:
Angle Right : 70
Zenith : 90
Slope Dist : 100 and then tap OK. The new point is computed
and stored. The Foresight point will automatically advance to