Fire-Lite SLC Intelligent Control Panel Wiring Manual - Manual (Page 8)

8 FireLite SLC Wiring Manual — P/N 51309:P1 10/12/2011
Section 1: Introduction
1.1 Scope
This document describes the operation, installation and wiring of various Signaling Line Circuit
(SLC) devices when used with the Fire-Lite MS-9200/MS-9200E, MS-9600/MS-9600E, MS-
9600LS/MS-9600LSC/MS-9600LSE, MS-9600UDLS/MS-9600UDLSE, MS-9200UD/MS-
9200UDE, MS-9200UDLS/MS-9200UDLSE/MS-9200UDLSC, and MS-9050UD/MS-
9050UDC/MS-9050UDE control panels. It also provides basic information that applies to Fire•Lite
SLC loops in general, such as the branch resistance measurements.
Additional information about the specific control panel and the modules and detectors referenced in
this document can be found in the respective installation manual as listed in Table 1.1, “Reference
Documentation,” on page 10.
Currently, there are two styles of modules available, legacy version and newer version. The obvious
difference between the two styles is the orientation of the rotary dials. Refer to the diagram below
for an example of each.
NOTE: Any reference in this manual to the MS-9200, MS-9200UD, MS-9200UDLS, MS-9600,
MS-9600LS, MS-9600UDLS, or MS-9050UD includes the MS-9200E, MS-9200UDE,
MS-9200UDLSE, MS-9200UDLSC, MS-9600E, MS-9600LSE, MS-9600LSC, MS-9600UDLSE,
MS-9050UDC, or MS-9050UDE respectively unless otherwise specified.
NOTE: Only the MMF-300, MMF-302, CRF-300, CMF-300, and MDF-300 modules are available
as newer type modules. Both the legacy and newer versions share the same part numbers. The
newer version modules will be phased in, replacing the legacy version. This manual contains
information and wiring diagrams for the newer version of the modules. Refer to “Terminal
Conversion Charts for New & Legacy Devices” on page 67 for additional information.
CMF-300
Legacy Version Module
(Vertical Rotary Dial)
CMF-300
Newer Version Module
(Horizontal Rotary Dial)