KYORITSU 6305 Instruction Manual - Manual (Page 109)

KEW6305
8.12
8-6 Saving data
When integration or demand measurement starts, the measured data will be saved automatically.
There are two locations where data can be saved.
* SD card : Max. 511 files can be saved.
* Internal memory : Max. 4 files can be saved.
Data is saved to a SD card automatically when a SD card has been inserted before turning on the
instrument. If the SD card has not been inserted, data is saved automatically to the internal memory
8.6.1 Saving procedure
* When a survey is started (manually or automatically) a file is opened
* Data is saved at the end of each integration interval (“Setting 09”).
Elapsed time
Demand interval
1 2 3 n-1 n
Start of demand Data saving point End of demand
(manually or preset time & date) (manually or preset time & date)
* When the survey is closed (manually or automatically) the file is closed
* All the recorded parameters at each data saving point are saved to one file.
NOTE
* Never set the Function switch to OFF position during a survey otherwise the measured data may be lost.
* In the following cases, the file number becomes “001”:
(1) when the file number has exceeded 999;
(2) after system reset
* If the same file no. exists, the old one will be overwritten.