A&D A & D Analytical Balance GH-120/GH-200/GH-300/GH-202/GH-252 - Manual (Page 38)

36
0 No limit t-Up
Timeout
1 1 second
Selects the wait time to receive a
command.
0 No output erCd
AK, Error code
1 Output
AK: ASCII code 06h
0 Not used
5if
Serial
interface
Ct5
CTS, RTS control
1 Used
Controls CTS and RTS.
0 Water temperature d5 fnc
Density function ldin
Liquid density input
1 Liquid density
Available only when density mode is
selected
Unit
Unit
Refer to "5. Weighing Units".
C5 in
Internal mass correction Displayed only when the internal mass value correction switch is set
to 1. Refer to "8. Calibration".
id
ID number setting
Refer to "11. ID Number And GLP Report".
: Factory settings. Digit is a unit of minimum weighing value.
Caution
The balance may not transmit the data completely at the specified refresh rate, depending
on the baud rate or data added to the weighing data such as time, date and ID number.