HP LaserJet 3055 - Manual (Page 110)

Changing the silence-detect mode
This setting controls whether or not you can receive faxes from older-model fax machines that do not
emit a fax signal during fax transmissions. At the time of this publication, these silent-model fax
machines represented very few of the fax machines in use. The default setting is Off. The silence-
detect mode setting should be changed only if you regularly receive faxes from someone who uses
an older-model fax machine.
To change the silence-detect mode
1. On the all-in-one control panel, press Menu .
2. Use the < or the > button to select Fax setup, and then press .
3. Use the < or the > button to select Fax Recv. setup, and then press .
4. Use the < or the > button to select Silence Detect, and then press .
5. Use the < or the > button to select On or Off, and then press to save your selection.
Creating stamp-received faxes
The all-in-one prints the sender identification information at the top of each received fax. You can
also choose to have your own header information included on each received fax to confirm the date
and time that the fax was received. The factory-set default for stamp-received faxes is Off.
NOTE This option applies only to received faxes that the all-in-one prints.
To make stamp-received faxes available
1. On the all-in-one control panel, press Menu .
2. Use the < or the > button to select Fax setup, and then press .
3. Use the < or the > button to select Fax Recv. setup, and then press .
4. Use the < or the > button to select Stamp faxes, and then press .
5. Use the < or the > button to select On or Off, and then press to save your selection.
92 Chapter 6 Fax ENWW