HP LaserJet 3055 - Manual (Page 345)

Control panel message Description Recommended action
Mem. low 1 copy. Press [cancel] The all-in-one completed making one copy.
The remaining copies have been canceled
because of low memory. Press Cancel to clear the error. Break the
job into smaller jobs that contain fewer
pages.
Memory is low Try again later The all-in-one does not have enough
memory to start a new job. Wait until the current job is finished before
starting a new job.
Memory is low. Press The all-in-one memory has been almost
completely filled. Allow the all-in-one to finish the job, or
press
to cancel the job.
Memory low Only 1 copy made The all-in-one does not have enough
memory to complete the collated copy job. Break the job into smaller jobs that contain
fewer pages.
No Dial Tone The all-in-one could not detect a dial tone. Check for a dial tone on the phone line by
pressing
Start Fax .
Unplug the telephone cord from both the all-
in-one and the wall and replug the cord.
Make sure that you are using the telephone
cord that came with the all-in-one.
Unplug the all-in-one telephone cord from
the wall, plug in a telephone, and try
making a voice call.
Plug the all-in-one phone cord into a jack
for another phone line. See
Changing the
detect-dial-tone setting .
If the error persists, contact HP Customer
Care. See
HP Customer Care or the
support flyer that came in the all-in-one box.
No document sent The all-in-one did not scan any pages, or it
did not receive any pages from the
computer to transmit a fax. Try sending the fax again.
No fax answer Redial pending The receiving fax line did not answer. The
all-in-one attempts to redial after a few
minutes. Allow the all-in-one to retry sending the fax.
Call the recipient to ensure that the fax
machine is on and ready.
Check that you are dialing the correct fax
number.
If the all-in-one continues to redial, unplug
the all-in-one telephone cord from the wall,
plug in a telephone, and try making a voice
call.
Plug the all-in-one phone cord into a jack
for another phone line.
Try a different phone cord.
If the error persists, contact HP Customer
Care. See
HP Customer Care or the
support flyer that came in the all-in-one box.
No fax answer. Canceled send Attempts to redial a fax number failed, or
the “Redial-no answer” option was turned off. Call the recipient to ensure that the fax
machine is on and ready.
Table 13-1 Alert and warning messages (continued)
ENWW Control-panel messages 327