Redialing manually, To redial manually – HP LaserJet 3055 User Manual
Page 92
Redialing manually
If you want to send another document to the last fax number that was dialed, use the following
procedure to redial manually. If you are trying to resend the same document that you sent the first
time, wait until the automatic redial attempts have stopped or until you have stopped them yourself.
Otherwise, the recipient might get the fax twice: once from the manual redial attempt and once from
one of the automatic redial attempts.
NOTE
To stop the current redial attempt for a fax, or to cancel all pending, automatic redial
attempts for a fax, see
. To change redial settings, see
.
To redial manually
1.
Load the document into the automatic document feeder (ADF) input tray or onto the flatbed
scanner.
2.
On the all-in-one control panel, press
Redial
.
3.
Press
Start Fax
. If the pages that you want to send are in the ADF, then faxing begins
automatically.
4.
If the all-in-one ADF sensor detects that no document is loaded into the ADF input tray, Send
from glass? 1=Yes 2=No appears on the control-panel display. To send the fax from the
flatbed scanner, press
1
to select YES, and then press .
After you press , Load page:X Press appears on the control-panel display.
5.
If you have already placed the document on the flatbed scanner, press (or place the
document on the flatbed scanner and then press ).
After scanning the page, Another page? 1=Yes 2=No appears on the control-panel display.
6.
If you have more pages to scan, press
1
to select YES, and then repeat step 5 for each page of
the fax job.
-or-
If you are finished, press
2
to select NO.
The all-in-one sends the fax to the number that it redialed. If the number is busy or does not answer,
the all-in-one redials the number based on its redial setting. If all redial attempts fail, the all-in-one
updates the fax activity log by adding the error.
74
Chapter 6 Fax
ENWW