HP LaserJet 3055 - Manual (Page 175)

Using the embedded Web server or HP ToolboxFX
You can use the embedded Web server (EWS) or HP ToolboxFX to view or change your IP
configuration settings. To gain access to the embedded Web server, type the IP address for the all-in-
one in the address line of your Web browser.
You can view HP ToolboxFX when the all-in-one is directly connected to your computer or when it is
connected to the network. You must perform a complete software installation to use HP ToolboxFX.
Open HP ToolboxFX in one of these ways:
● In the Windows system tray, double-click the HP ToolboxFX Device Status and Alerts icon.
● On the Windows Start menu, click Programs (or All Programs in Windows XP), click HP, click
HP LaserJet 3052/3055/3390/3392 all-in-one, and then click HP ToolboxFX.
In HP ToolboxFX, click Device Settings, and then click the Network Settings tab.
From the Networking tab (EWS) or the Network Settings tab (HP ToolboxFX), you can change the
following configurations:
● Host Name
● Manual IP Address
● Manual Subnet Mask
● Manual Default Gateway
NOTE Changing the network configuration may require you to change the browser URL
before you can communicate with the all-in-one again. The all-in-one will be unavailable for a
few seconds while the network resets.
Setting a network password
Set my network password
Use HP ToolboxFX to set a network password.
1. Open HP ToolboxFX and click Device Settings.
2. Click the Network Settings tab.
NOTE If a password has been set for the all-in-one previously, you will be prompted to
type the password. Type the password, and then click Apply.
3. Click Password.
4. In the Password box, type the password you want to set, and then in the Confirm password
box, type the same password again to confirm your choice.
5. Click Apply to save the password.
ENWW Using the embedded Web server or HP ToolboxFX 157