HP LaserJet 3055 - Manual (Page 177)

Automatic configuration
To perform automatic configuration
1. On the control , press Menu .
2. Use the < or the > button to select Network config., and then press .
3. Use the < or the > button to select TCP/IP config, and then press .
4. Use the < or the > button to select Automatic, and then press .
It may take several minutes before the automatic IP address is ready for use.
NOTE If you want to disable or enable specific automatic IP modes (such as BOOTP,
DHCP, or AutoIP), these settings can be changed by using the embedded Web server or
HP ToolboxFX only.
Link speed and duplex settings
To set link speed and duplex
NOTE Incorrect changes to the link speed and duplex settings might prevent the all-in-one
from communicating with other network devices. For most situations, the all-in-one should be
left in automatic mode. Changes can cause the all-in-one to power cycle. Changes should
only be made while the all-in-one is idle.
1. On the control , press Menu .
2. Use the < or the > button to select Network config., and then press .
3. Use the < or the > button to select Link Speed, and then press .
4. Use the < or the > button to select one of the following settings.
● Automatic
● 10T Full
● 10T Half
● 100TX Full
● 100TX Half
NOTE The setting must match with the network all-in-one to which you are connecting
(a network hub, switch, gateway, router, or computer).
5. Press . The all-in-one will power cycle.
ENWW Using the all-in-one control panel 159