HP LaserJet 3055 - Manual (Page 75)

Printing on both sides (Macintosh)
Automatic two-sided printing (duplexing) is available by using the automatic duplexer on the
HP LaserJet 3390/3392 all-in-one. Manual duplexing is available on the HP LaserJet
3050/3052/3055/3390/3392 all-in-one. To duplex manually, print on both sides of a page by feeding
the page through the all-in-one twice.
To print on both sides automatically (HP LaserJet 3390/3392 all-in-one)
1. Insert enough paper into one of the trays to accommodate the print job. If you are loading
special paper such as letterhead, load it in one of the following ways:
● For tray 1, load the letterhead paper with the front side up and the bottom-edge feeding
into the all-in-one first.
● For all other trays, load the letterhead paper with the front side down and the top edge at
the back of the tray.
CAUTION Do not load paper that is heavier than 105 g/m 2 (28-lb bond). Jamming might
result.
2. Open the printer driver (see Gaining access to the printer drivers ).
3. Open the Layout pop-up menu.
4. Next to Two Sided Printing, select either Long-Edge Binding or Short-Edge Binding.
5. Click Print.
To print on both sides manually (HP LaserJet 3050/3052/3055 all-in-one)
1. On the Print dialog, select Printer Features.
2. On the Feature Sets list, select Finishing, and then select Manually print on 2nd side.
3. Print the document.
4. After one side has been printed, remove the remaining media from the input tray, and set it
aside until after you finish your manual duplexing job.
HP LaserJet 3050 HP LaserJet 3052/3055
ENWW Using features in the Macintosh printer driver 57