HP StorageWorks XP Remote Web Console Software - Manual (Page 145)

TrueCopy for z/OS user guide 145
recordset errors. Hardware failures that affect the cache storage/shared memory of the MCU or RCU may
also cause the TC390A volume pairs to be suspended.
TrueCopy Software Error Codes
The TC390 software displays error messages on the Command View XP management station or XP Remote
Web Console when error conditions occur during TC390 operations. The error message describes the
error and provides a four-digit error code. The error code may include the
Table 29 Resolving TrueCopy Asynchronous suspension conditions
Classification Causes of Suspension SIM Recovery procedure
MCU/RCU
hardware
Hardware redundancy has been lost due to some
blockade condition. As a result, MCU-RCU
communication, creating or receiving recordset,
or the staging or de-staging process could not
complete.
The pending recordset cannot be retained
because one side of cache storage or shared
memory has been blocked due to hardware
failure.
MCU-Creating/sending recordset failed due to
unrecoverable hardware failure.
RCU-Reading/Settling recordset failed due to
unrecoverable hardware failure.
The drive parity group has been in the
correction-access status while the TC390 volume
pair was in pending state.
DB0x
DB1x
DB2x
According to SIM, remove the
hardware blockade or failure.
Re-establish failed volume pairs
(Resume Pair).
MCU-RCU
communication
During the power-on-reset sequence, the MCU
could not communicate with the RCU within the
specified RCU ready timeout.
The RCU could not settle the pending recordset
or could not communicate with the MCU before
the copy pending timeout due to MCU not-ready
or inoperative facilities on the remote copy
connections.
DB0x
DB1x
Remove the failed condition at
the RCU/MCU or on the remote
copy connection.
Re-establish failed pairs (Resume
Pair).
RIO overload The unrecoverable RIO (remote I/O) timeout
occurred due to overload of the RCU or the
communication facilities on the remote copy
connections.
No recordset could be sent within the specified
copy pending timeout.
The RCU could not settle the pending recordset
before the copy pending timeout due to overload
of the RIO or the RCU itself.
DB1x Delete failed pairs (Delete Pair).
Reconsider the performance
resources necessary and increase
resources as needed (cache
amount, number of MCU-RCU
paths, and so forth).
Re-establish failed pairs (Add
Pair).
RIO failure The RIO (remote I/O) could not complete due to
the failure at the RCU.
DB2x According to SIM generated at
the RCU, remove the failure.
Re-establish failed pairs (Resume
Pair).
MCU
planned outage
The TC390A pairs were temporarily suspended
due to a planned outage of the MCU.
DB8x No recovery procedure is
required. The MCU will
automatically remove the
suspension condition during the
next power-on-reset sequence.