HP StorageWorks XP Remote Web Console Software User Manual
Page 21
21
97
HXRC – Variable Sleep Wait timer duration (see modes 45, 85, 86; see ”
Mode 97 OFF: Sleep Wait timer duration = 100 ms.
Mode 97 ON: Sleep Wait timer duration = 10 ms.
98
HXRC – Selects SCP or session cancel (see modes 45, 85, 86; see ”
Mode 98 OFF: SCP.
Mode 98 ON: Forced session cancel.
104
TC390 CGROUP – Selects disk array default for CGROUP FREEZE option. Applies to 3990 emulation
only.
Mode 104 is invalid if the controller emulation is 2105. For 2105, use the CGROUP option of
CESTPATH.
Mode 104 ON: FREEZE enabled.
Mode 104 OFF (default): FREEZE disabled.
114
TC390 – Allows dynamic port mode setting (RCP/LCP for serial, Initiator/RCU target for Fibre Channel)
through PPRC CESTPATH and CDELPATH commands.
Mode 114 ON: Set defined port to RCP/LCP mode (serial) or Initiator/RCU target mode (Fibre
Channel) as needed.
Mode 114 OFF (default): Port must be reconfigured using Command View XP management station or
XP Remote Web Console.
For Fibre Channel interface, do not use the CESTPATH and CDELPATH commands at the same time as
the SCSI path definition function of LUN Management. The Fibre Channel interface ports need to be
configured as initiator ports or RCU target ports before the CESTPATH and CDELPATH commands are
issued.
Before issuing the CESTPATH command, verify that the relevant paths are offline from the host(s) (for
example, configure the Chipid offline, deactivate the LPAR, or block the port in the ESCD). If any active
logical paths still exist, the add path operation will fail because the port mode (LCP/RCP) cannot be
changed.
118
TC390A – SIM notification when the TC390A sidefile reaches high-water mark (HWM = sidefile
threshold - 20%) (see mode 93).
Mode 118 ON: Generate SIM.
Mode 118 OFF (default): No SIM generated.
NOTE:
The reported SIM when this mode is ON is not reported per CLPR.
Table 3
XP128/XP1024/XP10000/XP12000 modes for TrueCopy for z/OS (continued)
Mode
Description