Serial interface configuration, Figure 15 setting the async options, 15 setting the async options – HP StorageWorks XP Remote Web Console Software User Manual
Page 52
52
TrueCopy for the XP128/XP1024/XP10000/XP12000
NOTE:
At this time serial interface and Fibre Channel interface configurations cannot coexist for the same
MCU. Future support is planned.
Serial interface connection is not supported for this version.
Serial Interface Configuration
To configure the MCUs and RCUs for serial-interface TC390 operations:
1.
Identify the volumes that will become the TC390 M-VOLs and R-VOLs. You need to know the disk array
S/N, SSID, and CU image of each TC390 volume so that you can configure the MCUs and RCUs
correctly for the appropriate pairs and async groups. When you create the pairs, you will need to know
the port, group ID, and LUN of each volume.
2.
Connect to the disk array that you want to configure as a TC390 MCU.
NOTE:
You must operate the Command View XP management station or XP Remote Web Console
in Modify mode to perform TC390 operations. Users in view mode can only view TC390
information.
3.
From the Identity window, click the Mainframe tab, and then click the TrueCopy button (
) to start the
TC390 software. The TrueCopy main window is displayed and the Pair Operations tab is displayed at
the top.
4.
Configure the serial interface ports that are connected to the RCUs as RCPs by the Port Change
operation.
5.
Register the RCU(s) to the current MCU CU image using the Add RCU window and set the options for
the registering RCU using the RCU Option window. For additional instructions, see ”
6.
If you plan to create TC390A pairs with M-VOLs in this MCU, configure the MCU async options as
shown in the following figure. For additional instructions, see ”
Figure 15
Setting the Async options