Aastra Telecom AastraLink Pro 160 - Manual (Page 120)

Configuring System Settings
4-10 41-001190-02 Rev. 01, Rel. 1.2
AastraLink Pro 160 Administrator Guide
Specifying the Date and Time
If automatic time and date were enabled during the initial administrator setup of
the system (default set to yes during initial setup), the AastraLink Pro 160 uses the
Network Time Protocol (NTP) to synchronize its date and time from the Internet
global time servers (pool.ntp.org). If Internet access is not available, then use the
following procedure to manually set the date and time for your AastraLink Pro
160.
AastraLink Web UI
Step Action
1 Select Configuration->System->Set Date/Time.
2 In the “Date” field, specify the date that the AastraLink Pro displays on the IP phones in your network.
3 In the “Time” field, specify the time that the AastraLink Pro displays on the IP phones in your
network. Default is the current time set on the AastraLink Pro 160.
4 Click <Save> to save your changes.