Aastra Telecom AastraLink Pro 160 - Manual (Page 133)

Configuring Network Settings
41-001190-02 Rev. 01, Rel. 1.2 4-23
Configuring AastraLink Pro 160 System and Network Parameters
• Use DHCP
Enables or disables Dynamic Host Configuration Protocol (DHCP), in order
to support dynamic/static addressing. DHCP is enabled on the AastraLink Pro
160 by default. If DHCP is enabled, but no DHCP server responds to the
AastraLink Pro address request at boot time, the AastraLink falls back to
using ZeroConf link-local IP addressing.
• IP Address (required if DHCP is disabled)
IP Address you specify for your AastraLink Pro 160 if DHCP is disabled.
• Subnet Mask (required if DHCP is disabled)
Subnet Mask you specify for your AastraLink Pro 160 if DHCP is disabled.
• Gateway (required if DHCP is disabled)
Default Gateway IP Address you specify for your AastraLink Pro 160 if
DHCP is disabled.
• DNS Server 1
IP Address you specify for the Domain Name Server (DNS) server 1.
• DNS Server 2
IP Address you specify for the DNS server 2.